#Vox ac30cc2 sound manual#
#Vox ac30cc2 sound professional#

If it were me, id prolly go C2, as its tremolo and reverb are MUCH better and usable, and a little lighter as well. To me the cc2 sounded more 'fendery' but still had the vox thing going on, while the c2 seemed more tight and focused all around. Messages: 1, To me the cc2 was louder and a little differnt in tone overall due to the GZ34 rectifier. The C2 not only sounded much better to my ears, it's also a better investment if one day you plan on selling it. I owned both and there's no doubt in my mind that the C2 had a clear edge in tonal quality over the CC2x. CC2 is tube rectified and that tube and will blow frequently unless you know not to ever touch the standby switch. I would also like some information on this subject. Messages: Which one do you prefer, and why? Unfortunately I'm not able to test them next to each other so I need you help! AC30c2 vs AC30cc2: your thoughts? Warning: You should never plug a speaker level signal into a source expecting anything less than a speaker level signal.Pb_user_ / Octo/ Vox ac30cc2 rectifier / commentsР”Вiscussion in ' Amps and Cabs ' started by HugoOct 18, Log in or Sign up. These signals are much higher in voltage than line level and require speaker cables for safe signal transfer. After a line level signal enters an amplifier, it exists to the speakers at what is called speaker level. Speaker level signals are post amplification. Warning: Be careful not to send a line level signal to a preamplifier expecting a mic or instrument level signal.

#Vox ac30cc2 sound professional#

Professional line level is rated around +4 dBu and can be found in equipment like mixing desks, preamplifiers, and signal processing equipment. The two types of line levels are consumer and professional.Р”В¬onsumer line level is rated around -10dBV and is what youРІР‚в„ўll find in products like a CD player. This is the type of signal that typically flows through your recording system after the preamplifier stage and before the amplifier that powers your speakers.

Line level signals are the highest level signals before amplification. A preamplifier is required to bring the signal up to line level. These signals refer to any level put out by an instrument, commonly from an electric guitar or bass. Instrument level signals fall between mic level (lower) and line level (higher) signals. This is the lowest, or weakest, level signal of the four and requires a preamplifier to bring it up to line level. Mic level is the voltage of signal generated by a microphone. Also curious.Р”Р‡ound this on, butwould piezo pr active pickups edge closer to line level?

#Vox ac30cc2 sound manual#

Although, it was bought new I did not get a manual or display box with the amp because they didnРІР‚в„ўt have it in the shop.Р”В¬lick to expand.And guitar level/ passive pickups is usually below mic level? Or same? I thought piezo pickups tend to be close to mic level. If this info is in the amp manual, please advise me of that and IРІР‚в„ўll read it online. This is a bit annoying because I would ideally like the guitar to go into the PA as well but without it sounding so very different to whatРІР‚в„ўs coming out of the amp. This is a bit of a nightmare!Р”Вoes anybody know why there should be a difference between the sound of the guitar out of the amp speaker and the sound of it from the extension speaker output though the PA? Is it because the Vox amp speakers are different and making it sound better or is the signal the extension speaker out is sending somehow different to what the amp speaker is getting? It gets less bad though the PA when you turn it up in the PA but I donРІР‚в„ўt want it any loader in the PA for reasons of balance of volume with the vocal. WhatРІР‚в„ўs more when the guitar channel on the PA is at itРІР‚в„ўs quietest setting it sounds really bad through the PA but obviously still awesome out of the amp speaker. However, when practicing with a PA system I use the extension speaker output to put the guitar though the PA as well as out of the amp speaker and I have noticed the sound though the PA (clean and distorted) is very different to the sound of it out of the amp speaker.